Display Assembly - HP Chromebook 14-X0 SERIES Maintenance And Service Manual

Display assembly

Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see
Remove the display assembly:
1. Release the ZIF connector (1) to which the display panel cable is attached, and then disconnect the
display panel cable from the system board.
2. Disconnect the wireless antenna cables (2) from the WLAN terminals on the system board and WWAN
terminals on the WWAN module.
NOTE:
The black WLAN antenna cable labeled "2/Aux" connects to the system board "Aux" terminal.
The red WWAN antenna cable labeled "5/Main" connects to the WWAN module "Main" terminal. The blue
WWAN antenna cable labeled "6/Aux" connects to the WWAN module "Aux" terminal.
3. Release the wireless antenna cables from the routing clips (3) built into the base enclosure.
4. Remove the two Phillips PM1.9×3.3 screws (4) that secure the display assembly to the base enclosure.
5. Remove the display assembly (5).
NOTE:
TouchScreen display assembly. See steps 10 through 14 for disassembly instructions for computer
models equipped with a non-TouchScreen display assembly.
6. If it is necessary to replace the display enclosure or any of the display assembly subcomponents:
40 Chapter 5 Removal and replacement procedures
The white WLAN antenna cable labeled "1/Main" connects to the system board "Main" terminal.
Steps 6 through 9 provide disassembly instructions for computer models equipped with a
Keyboard/top cover on page 25).