Table of Contents
Advertisement
5.
Release the ZIF connector (5) to which the connector board cable is attached, and then disconnect the
connector board cable from the system board.
6.
Remove the four Philllips PM1.9×2.4 broad head screws (1) that secure the system board to the
base enclosure.
7.
Lift the right side of the system board (2) until it rests at an angle.
8.
Remove the system board (3) by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.
36
Chapter 5 Removal and replacement procedures
Advertisement
Table of Contents
