Table of Contents
Advertisement
3.
Remove the two rubber screw covers (1).
4.
Remove the two rear rubber feet (2).
5.
Remove the middle rubber screw cover (3).
NOTE:
The display bezel screw covers are included in the Rubber Kit, spare part number 787721-001
for use only on HP Chromebook 14 PC, and 788510-001 for use only on HP Chromebook 14 G3.
6.
Remove the thirteen Phillips PM1.9×5.7 screws that secure the keyboard/top cover to the
base enclosure.
7.
Turn the computer right side up with the front toward you.
8.
Open the computer as far as it will open.
9.
Lift the front edge (1) of the keyboard/top cover until it separates from the front edge of the
base enclosure.
10.
Lift the left (2) and right sides of the keyboard/top cover until they separate from the left and right
sides of the base enclosure.
11.
Disconnect the battery cable (3) from the system board.
12.
Release the zero insertion force (ZIF) connector (4) to which the keyboard cable is attached, and then
disconnect the keyboard cable from the system board.
Component replacement procedures
27
Advertisement
Table of Contents
