CROSS CiRCUIT PRO KIT for LateralX
Kit Contents
Left Side Weight Stand
Right Side Weight Stand
Assembly and Safety Instructions
End Caps (2)
Hardware Kit (see illustration)
Tools Required
5mm hex key wrench (included)
6mm hex key wrench (included)
#2 Phillips screwdriver
Assembly Instructions
Remove Phillips screws (Qty 3)
and plastic covers.
Place weight stand on machine;
insert pin (A).
Assemble
bolt
washer (C) (Qty 2) and insert
at rear of stabilizer; tighten to
10 ft-lbs.
Assemble bolt (B) and washer
(C) (Qty 1), insert in pin (A) and
tighten to 10 ft-lbs.
Install end cap.
Repeat - for other side.
(B)
and
ENG-1