Defender CA6000 Owner's Manual page 11

DISPLAY CO LEVEL BUTTON (FOR MODEL CA6050): To manually display the
current and highest CO level detected, press the
LCD will display the recorded data in the following order:
1. The current CO level detected, and
2. The peak or highest CO level detected from 10-999 ppm.
3. The total length of time the alarm has detected the peak CO level, from 0-999
minutes.
Each reading will appear for five seconds. To erase the record in memory, press the
TEST/RESET/MUTE
beep, and the display reads
9. TEST AND MUTE ALARM
To test your alarm, press the
for a minimum of 2 seconds or until the alarm starts beeping and
flashes, then release. This test will simulate a CO concentration of approximately 300
ppm CO gas. The alarm will sound 4 short beeps and LED will flash Red at the same
time, followed by a 5 second pause, and then repeat 4 more short beeps with flashing
Red LED if all of the electronic circuitry and buzzer are working correctly. The current
CO level will also be displayed for model CA6050.
To mute the audible horn during an alarm signal, press the
The ALARM red LED will flash 4 times, the model CA6050 will display
seconds, and the horn will be temporarily silenced. If a CO level of 70 ppm or more
continues to be detected, the audible and visual alarm signals will be automatically
reactivated within 5 minutes.
.
SOUNDS
To mute the audible horn during a low battery signal (
TEST/RESET/MUTE
will display at the same time, and the horn will be temporarily silenced for 24 hours.
The low battery signal symbol
When the audible signal reactivates, you can continue to mute the horn for an additional
24 hour period by again pressing the
turned off during the first 7 days of the low battery signal activation.
alarm will return to its normal low battery signal condition; 1 chirp per minute, green LED
blinks for 5 seconds, and model CA6050 continuously displays
To test your alarm during a low battery signal condition, press and hold
TEST/RESET/MUTE
sounding.
To mute the audible
TEST/RESET/MUTE
CA6050 will display
60 hours. When the audible signal reactivates, you can continue to mute the horn for
an additional 60 hour period by again pressing the
can only be turned off during the first 30 days of the "End-of-Life" signal activation. After
button when the readings are displayed. The alarm will burst a long
.
TEST/RESET/MUTE
See Section 10
button. The green LED will blink for 5 seconds, the model CA6050
will be continuously shown in the CA6050 display.
TEST/RESET/MUTE
button for minimum 2 seconds when the audible signal is not
signal during
button. The
SERVICE
at the same time, and the horn will be temporarily silenced for
DISPLAY CO LEVEL
button on the cover and hold it down
WHAT TO DO WHEN THE ALARM
button. The horn can only be
an "End-of-Life"
red LED will glow for 5 seconds, the model
TEST/RESET/MUTE
- 11 -
button once. The
red LED
ALARM
TEST/RESET/MUTE
) condition, press the
After 7 days, the
.
condition, press
button. The horn
button.
for 5
the