Replacing The Blades; In The Event Of A Thunderstorm - Husqvarna 265 ACX Operator's Manual

1157068-26,265ACX_GB.book Page 72 Friday, November 28, 2014 9:06 AM

8.6 Replacing the blades

WARNING
Always use originalblades and
screws when replacing.
Only replacing the blades and
reusing the screw can result in the
screw wearing during mowing and
shearing off. The blades can then be
thrown out and cause serious injury.
On Automower five blades are screwed onto the
®
blade disc. All five blades and screws must be
replaced at the same time to ensure the cutting system
is balanced.
There are several different types of mower blades to
choose from as accessories, with different features.
Use Husqvarna AB approved blades only. Please
contact your dealer for more information.
To replace the blades:
1. Set the main switch to the OFF position.
2. Wear protective gloves.
3. Turn Automower
4. Rotate the skid plate so that its hole aligns with
the screw for the blade.
5. Unscrew the blade. Use a straight slot or
cross-tip screwdriver.
6. Pry apart the skid plate and blade disc a little and
remove the blade and screw.
7. Screw tight the new blade.

8.7 In the event of a thunderstorm

To reduce the risk of damage to electrical
components in the robotic lawnmower and its
charging station, we recommend that all connections
to the charging station are disconnected (power
supply, boundary wire and guide wires) if there is a
risk of a thunderstorm.
1. Make sure the wires are marked with the supplied
markers to simplify reconnecting. The charging
station's connections are marked AR, AL and
Guide.
2. Disconnect all wires.
3. Close the cover to the charging station to protect
the connections from rain.
4. Connect all the wires if there is no longer a risk of
thunder. It is important that each wire is connected
to the right place.
72 - English
8. MAINTENANCE
upside down.
®
OFF
1.
2.
3012-288
3012-272
3012-260
3012-1095