Husqvarna 265 ACX Operator's Manual page 31

1157068-26,265ACX_GB.book Page 31 Friday, November 28, 2014 9:06 AM
Joining the boundary wire
If the boundary wire is not long enough and needs to
be spliced: Use original solderless coupler. It is
waterproof and gives a reliable electrical connection.
Insert both wire ends in the coupler. Make sure the
wires are fully inserted in the coupler by checking that
the wire ends are visible through the transparent area
on the other side of the coupler. Now press down the
button on top of the coupler fully. Use a polygrip to
completely press down the button on the coupler.
IMPORTANT INFORMATION
Twisted cables, or a screw terminal
(chock-block), insulated with insulation tape
is not a satisfactory splice. Soil moisture will
cause the conductors to oxidise and after a
while result in a broken circuit.
3. INSTALLATION
3018-055
English - 31