Checking The Installation; Linking Automower To The Charging Station - Husqvarna 265 ACX Operator's Manual

1157068-26,265ACX_GB.book Page 34 Friday, November 28, 2014 9:06 AM
7. Refit the cover on the charging station. Ensure
the three guides on the charging station enter the
right holes in the cover.

3.6 Checking the installation

Check the loop signal by looking to see what
indication the green LED on the charging station is
giving.
• Steady light = the signal is okay.
• Flashing once every other second = break in the
loop and no signal found.
• Flashing twice every other second = weak signal.
This may be due to the boundary wire exceeding
500 metres or that the cable is damaged. If the
mower works, it is not a problem. In case of
operational disturbance, we recommend a Signal
amplifier (522 42 58-01) which is available as an
accessory. This allows a boundary wire of up to
800 metres.
3.7 Linking Automower
charging station
1. Open the control panel cover by pressing the
STOP button.
2. Place Automower
3. Set the main switch to the ON position.
A start-up sequence begins when Automower
started for the first time. The following is
requested: Language, time format, correct time,
date format, date, and four-digit PIN code. All
combinations except 0000 are permitted.
When you have chosen a PIN code with Automower
placed in the charging station, the mower and
charging station are then linked to each other.
34 - English
3. INSTALLATION
® to the
in the charging station.
®
®
is
®
3012-270
3012-282
ON
OFF
3012-906
3012-408