Assembly; Fitting The J-Handle; Assembling And Dismantling The Two- -Piece Shaft - Husqvarna 128DJX Operator's Manual

NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.

Fitting the J-handle

S Clip the loop handle onto the shaft.
Note that the loop handle must be fitted
between the arrows on the shaft.
S Slide the spacer into the slot in the loop
handle.
S Fit the nut, knob and screw. Do not over-
tighten.
S Attach the J- -handle to the loop handle
using the three screws as shown.
S Make a final adjustment of the handle to a
comfortable working position. Tighten the
bolt/knob.
WARNING:
Only grass blades/
grass cutters or trimmer heads/plastic
blades may be used when the
J- - handle is fitted. Saw blades must
never be used with the J- - handle.
Assembling and dismantling
the two- -piece shaft

Assembly:

S Loosen the coupling by turning the knob.
577387001 Rev. 2 1/6/11
ASSEMBLY
S Align the tab of the attachment (A) with
the arrow on the coupling (B).
S Push the attachment into the coupling until
the attachment snaps into place.
ENGINE
S Before using the unit, tighten the knob se-
curely.
Dismantling:
S Loosen the coupling by turning the knob
(at least three times).
S Push and hold the button (C). While
securely holding the engine end, pull the
attachment straight out of the coupling.
C
B
A
English--- 10