Changing The Oil; Adjusting The Clutch Wire - Husqvarna LC 48 Operator's Manual

Changing the oil

The engine oil should be changed each year and every 25
working hours.
When changing the oil proceed as follows::
• Empty the fuel tank by running the machine until the tank
is empty.
• Disconnect the HT lead from the spark plug.
• Unscrew the oil filler cap.
• Use the oil pump (accessory) to empty the oil tank.
Ask where you can dispose of surplus engine oil at your
local petrol station.
• Fill with new engine oil of a good quality. See the Technical
data section.
• Check the oil level with the dipstick on the oil filler cap.
• The oil filler cap must be completely screwed down to give
a correct picture of the oil level. If the oil level is low, fill
using engine oil up to the upper level on the dipstick.
• Screw on the oil filler cap.
Charge the battery LC 48 VE
The battery can be charged as follows:
• Push the locking open and remove the battery cover.
80 –
English
MAINTENANCE
• Loosen the battery cable connections.
• Connect the battery charger and charge the battery for
max. 24 hours.
Cleaning cutting cover
• Connect a water hose to the cutting cover connection.
• Start the engine and let the blade rotate for a while. The
water is thrown out and cleaning the cutting cover.

Adjusting the clutch wire

The clutch wire is adjusted by turning the adjustment screw.
max
24 h