Palm Pre Pre Plus User Manual page 166

10 Position the back cover over the phone and gently press the top two
clasps (a), located at the top corners. Then press the two clasps (b)
halfway down either side of the phone.
11 Slide out the keyboard (see
two clasps (c) at the bottom corners.
166 Chapter 11 : Troubleshooting
Slide out the keyboard), and then press the
12 Press and hold the power
phone until you see a logo on the screen (approximately five seconds).
Please be patient while your phone starts up.
If your phone does not turn on after you insert the battery and press and hold
TIP
power, you may need to charge the battery (see
I can't get my screen to turn on after removing and replacing
the battery
Removing the battery turns off your phone completely, so you can't just slide
out the keyboard or press power
and hold power until you see a logo on the screen (approximately five
seconds). Please be patient while your phone starts up.
TIP If your phone does not turn on after you press and hold power, you need to
connect your phone to the AC charger to charge it (see
I can't get the back cover off
1 If the USB cable is attached to the phone, disconnect the USB cable.
2 If a wired headset is attached to the phone, disconnect the headset.
3 Turn the phone completely off (see
wireless services) on/off).
button on the upper-right corner of your
Charge the battery).
to turn on the screen. Instead, press
Charge the battery).
Turn everything (the screen and