Keypad Identification - Techfrost JOF ONE Owner's Manual

BLAST FREEZING (-40°C)
Make sure the device is "on."
***
Press the key
You can modify the default temperature setting of -40°C by, pressing the key
▼
the key to decrease the temperature. (This option is active only before starting the program)
Press the key ON/OFF to start the BLAST FREEZING phase
The BLAST FREEZING phase will last 240 minutes.
You can modify the time of the BLAST CHILLING phase by, pressing the key
▼
key to decrease the time. (This option is active only after having started the program)
Once the completion of the 240 minute cycle, the device will pass into conservation (setpoint -20°C)
WARNING: The BLAST FREEZING HARD phase is set by default. If the HARD key is pressed before
starting the cycle , HARD is stopped and the SHOCK FREEZING will cease even if in the BLAST FREEZING
phase w/ temperature setting of 0°C.
GELATO PROGRAM
To use the shock freezer for Gelato it is recommended to select a BLAST FREEZEING cycle and choose a
maximum time of 500 minutes. This way, the machine will always work at its maximum despite the continuous
door opening during gelato production.
Manual defrosting start
Make sure that the cycle is over and that no procedure is on.
Press and hold the key
The defrosting will last 20 minutes. Leave the door open during the defrost phase.
The drawing below is an illustration of the electronic panel
Distributed By:
BLAST FREEZING: the LED
▲
for 4 s: the LED DEFROSTING

6) KEYPAD IDENTIFICATION

and the LED HARD will flash.
▲ to
will switch on.
Street:5C Wendy Ct. Greensboro, NC 27409▪Mailing: PO Box 18542,
Greensboro, NC 27419▪P:336-856-2919▪F:336-217-8838
Email:Sales@AdvancedGourmet.com▪Web:www.AdvancedGourmet.com
increase the temperature or
▲
to increase the time or the
P a g e | 9