Libelium waspmote plug & sense Technical Manual page 125

Interacting with Waspmote Plug & Sense!
Both process ("Load MAC" and "Check status") require the ZigBee capturer daemon to be stopped. This means no frames
will be received while executing this actions. Be patient this can take up to 1 minute to finish.
Figure : XBee parameters configuration
Note: When you buy a Waspmote Developer kit with Meshlium and with the XBee ZB as ZigBee radio both the Waspmote GW and
Meshlium come configured as Coordinator of the network. Take into account that only one of them can be working at the same time.
Note: If the encryption check fails but the rest of parameters are OK, it means the radio has an old version of the firmware but it is
working perfectly.
-125- v5.8