Canon WUX6000 User Manual page 68

Split-Screen Display
4
Use the [ ] / [ ] buttons to select [On], and then press the OK button.
• A number is displayed in the center of one image area. When the image at left is
selected, 1 is displayed on the left, and when the image at right is selected, 2 is
displayed on the right. The image labeled with a number has "control rights," and the
sound for that image will be played. This is also the image with control rights if you
adjust [Image priority]. (P83)
• These functions cannot be adjusted in this mode: sharpness (P87), dynamic gamma
(P91), noise reduction (P90, P91), lamp control (P94), and motion blur reduction
(P103).
• Some functions are not available, such as [Image flip H/V] (P141), [Screen aspect]
(P142), [Keystone] (P144), [Zoom] (P143), and [Logo capture] (P96).
• Image mode colors differ somewhat from those in single-image mode.
5
If or
control to the other side by pressing the [ ] / [ ] buttons on the remote
control.
6
Press the INPUT button, and then press the [ ] / [ ] buttons on the
remote control to select the input signal for the side with control rights.
The [Input] menu is displayed. To determine which side currently has control
rights, check whether 1 or 2 is shown in orange in the upper right of the menu.
As for input signals, the source used for the side with control rights is labeled
with a green circle, and the source used for other side is labeled with a white
circle.
For details on selecting input signals, refer to "Selecting an Input Signal" (P40).
Downloaded from ProjectorsManual.com Manuals
is displayed in the center of the image area, you can switch
(Example of display in split-screen mode.)
68