Table of Contents
Advertisement
GAS FIRE INSTALLATION
There are 2 options of installation type.
Option 1 - When installing without a decorative fire frame, prior to fitting this natural
stone fireplace, the gas appliance associated with it must first be installed by a
fully qualified Gas Safe registered engineer. The gas appliance must be fully
sealed to the fireplace opening before fitting the limestone fireplace.
Option 2 - When installing with a decorative fire frame, the limestone back panel
must be fitted first and fully sealed to the fireplace opening. The gas appliance
must then seal against the back panel.
For more information on the installation of the gas appliance please refer to the
relevant installation documentation that came with the appliance.
When fitting the fireplace with a four piece back panel the gas appliance is raised
from the hearth level. It is essential that the gas appliance is installed and sealed
in the correct position of the wall in relation to the fireplace opening created by
the four-piece back panel and hearth. The diagram and table below indicates
the finished opening for each fireplace.
When fitting the fireplace with a three piece back panel the gas appliance should
be installed at hearth level.
A
Note that natural materials such as Portuguese limestone can have slight
variances in thickness. Please measure components to ensure that they
correspond to the measurements given above. If necessary make any relevant
adjustments.
INSTALLATION
MODEL
A
500
50 100 550 490
PALERMO
500
50 100 550 490
VICENZA
600
55 110 590 444
NAPOLI
600
55 200 590 444
VERONA
800
55 240 790 444
MESSINA
800
55 110 790 444
ABRUZZO
All dimensions in mm.
B
C
D
Advertisement
Table of Contents
