Important Information - BMW R50 Installation Instructions Manual

Important information

The retrofit kit is only for use within the dealership organisation.
Do not kink or damage the cables during the installation work since otherwise they may cause faults that can
later only be identified by extensive additional work. The costs incurred as a result of this will not be
reimbursed.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead terminals must be used.
This system does not require coding
Target group
The target group for these installation instructions is specialist personnel trained on MINI cars with specialist
knowledge of vehicle electrical systems.
Work:
All servicing, repair and installation work on MINI cars is completed at your own risk.
All work is to be carried out using current MINI repair manuals and circuit diagrams in a rational order using
the prescribed tools (special tools) and observing current health and safety regulations.
Required special tools
Crimping pliers for AMP contacts
Twist drill 5 mm
Step drill bit
Drill
Retrofit / Installation kit No. 84 64 0 139 563 / 84 64 0 142 864 EN/3
Installation Instructions No. 01 29 0 142 863 Issue date: 10.2001