Display Assembly - Dell Inspiron Mini 9 910 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 910 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You
2. Remove the module cover (see
3. Remove the keyboard (see
4. Remove the palm rest (see
1 Mini-Card antenna cables
5. Turn the computer over, make note of the cable routing, and carefully dislodge the Mini-Card antenna cables from their routing guides.
6. Pull the Mini-Card antenna cables through the system board as shown in the figure.
Begin.
Removing the Module Cover).
Removing the Keyboard).
Removing the Palm Rest).