Dell Inspiron Mini 9 910 Service Manual page 14

1 display cables 2
3 speaker cable
7. Disconnect the display cables and the speaker cable from the respective system board connectors.
8. Make note of the display cables and the speaker cable routing and carefully dislodge from their routing guides as shown in the figure.
9. Remove the two screws from the display assembly hinges.
10. Remove the display assembly from the computer base.
1 display cable connectors
3 speaker cable connector
Replacing the Display Assembly
1. Align the display hinges with the holes in the base of the computer and then lower the display into place.
2. Replace and tighten the two display assembly hinge screws.
3. Carefully route the display cables and the speaker cable into their routing guides and connect them to the respective system board connectors.
4. Carefully slide the Mini-Card antenna cables through the system board and into their routing guides.
5. Replace the palm rest (see
6. Replace the keyboard (see
7. Replace the module cover (see
8. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
Mini-Card antenna cables
2 screw (2)
Replacing the Palm Rest).
Replacing the Keyboard).
Replacing the Module Cover).