Receiving And Inspecting The Unit - WhisperKool SC 2000i Owner's Manual

RECEIVING AND INSPECTING THE UNIT

Upon Receiving the WhisperKOOL Cooling Unit
• Lift only at the designated hand hold locations on the shipping container or fully support the unit from underneath.
A shipment may include one or more boxes containing accessories.
• Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
• Note any discrepancies or visual damage on the Bill of Lading before signing.
• Place the box containing the WhisperKOOL unit on a tabletop to prepare it for testing prior to installing.
• Sit unit upright for 24 hours.
WhisperKOOL units are manufactured in the USA and tested prior to shipment.
Note:
Review the Packing Slip to Verify Contents
• Check the model number to ensure it is correct.
• Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
Check the Box for the Following Contents:
2000i / 3000i / 4000i
Single Piece Mounting Bracket
Accessory Kit One:
• WhisperKOOL Owner's Manual
• Bypass Plug
• Bottle Temperature Probe
Accessory Kit Two:
• 8' Power Cord
• Mounting Bracket Insulation Foam 14.5" (2)
• Mounting Bracket Insulation Foam 18" (2)
• 1¾ Standard Screws (11)
• ½ Self-Tapping Screws (6)
• ³ � ₈ x ¼ Barbx FNPT Fitting
• Drain Line Tube (1)
• Connection "T" (1)
• Magnetic Deflectors for Airflow Control (2)
Please leave the WhisperKOOL unit in its original box until you are ready for installation. This will allow you to move the product
safely without damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
contact WhisperKOOL Customer Service immediately.
6000i / 8000i
Single Piece Mounting Bracket
Accessory Kit One:
• WhisperKOOL Owner's Manual
• Bypass Plug
• Bottle Temperature Probe
Accessory Kit Two:
• Power Cord
• Mounting Bracket Insulation Foam 14.5" (2)
• Mounting Bracket Insulation Foam 25" (2)
• 1¾ Standard Screws (11)
• ³ � ₈ Self-Tapping Screws (6)
• ³ � ₈ x ¼ Barbx FNPT Fitting
• Drain Line Tube (1)
• Connection "T" (1)
• Magnetic Deflectors for Airflow Control (2)
SC Series
www.whisperkool.com | Page 5