Table of Contents
Advertisement
16 Built-In Installation/Start-Up
Door ajar alarm:
If the door is open, or not closed
properly for 5 minutes the "DOOR"
indicator will illuminate and flash and
an audible tone will sound. This alarm
condition can be reset by closing the
door or momentarily pressing the "ON/
OFF" icon, (i.e.-if you are cleaning the
storage compartment, etc.). The alarm will
recur in 5 minutes if the alarm condition
persists.
If the door is intentionally left open for long
periods, the alarm can be disabled by
turning the unit off.
Options menu
Normal and ECO mode:
Your ice machine comes with an optional
"ECO" mode. While in this mode ice
production will slow and the appliance
will use less water and electricity. "ECO"
mode should only be used after there is a
full bin of ice. To enter "ECO" mode do the
following:
•
Press the "MENU" icon twice
and the green "ECO" will flash.
•
Press and hold the "ON/OFF"
icon until the green "ECO" stops
flashing and remains illuminated.
•
To return to the standard
operating rate press the "MENU"
icon twice, the ECO will turn off
and the "ICE" will be flashing. Press
and hold the "ON/OFF" icon until
the "ICE" stops flashing and
remains illuminated.
Clean mode:
To clean your ice machine you will need
to purchase a "nickel safe" ice maker
cleaner. Cleaner is available at most
appliance retailers or through the cleaners
website. Several recommended cleaners
are listed below:
•
Kirby's Certified ice machine cleaner.
100% nickel safe.
•
Nu-Calgon nickel safe ice machine
cleaner.
•
Franklin Machine Products Nickel
safe ice machine cleaner.
Once you have your cleaner:
Turn the ice machine off by pressing
DOOR
and holding the "ON/OFF" icon for
3 seconds. "OFF" will be displayed
on the control.
Remove the grid cutter cover (Figure 1)
by pulling the cover off of the three rubber
isolation mounts.
Remove all ice from the ice bin (Figure 1).
ECO
Allow all of the ice to fall from the
evaporator plate and remove any ice from
the grid cutter. If there is ice embedded in
the grid cutter wires, wait for it to melt and
fall out. Do not try to remove ice that is
embedded in the grid cutter wires as that
may break the wires (Figures 2 and 3).
ICE
CAUTION
Forcing ice through the grid cutter
will break the grid cutter wires.
OFF
Remove the
grid cutter
cover
Remove all
of the ice
from the
ice bin
Figure 1
Figure 2
Remove all ice from
the evaporator plate
and grid cutter area
that is not embedded
in wires
Figure 3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
