Electrolux UL15IM20RS Use And Care Manual page 17

Drain the water from the water reservoir,
by removing the black plug from the
bottom of the fresh water reservoir (Figure
4). After the water is drained replace the
plug in the bottom of the reservoir and
firmly press into place (Figure 4b).
Refer to your cleaning solution instructions
to determine the proper amount of
cleaning solution to add based on 3 quarts
(2.8 liters) of water. Pour the cleaning
solution between the evaporator plate and
the grid cutter so it flows down into the
fresh water reservoir (Figure 5).
Pour cleaning solution into
the water reservoir at front
Evaporator
edge of evaporator plate
Plate
behind the grid cutter.
Grid Cutter
Figure 5
Built-In Installation/Start-Up
Figure 4
Remove the
black reservoir
drain plug from
the bottom of
the reservoir.
Figure 4b
The plastic splash shield can be removed
by lifting off hanger brackets to improve
access (Figure 6).
Splash shield hanger brackets
Figure 6
Turn the ice machine back on by
pressing and holding the "ON/OFF"
icon for 3 seconds. The display will
indicate "ICE" mode. Press and
hold the "MENU" icon until a
flashing "CLEAN" is displayed. Press
the "ON/OFF" icon until "CLEAN"
stops flashing. Your ice machine
will now enter the clean cycle.
The clean and rinse cycle will take about
49 minutes.
After the clean cycle is complete the ice
machine will return to the "OFF"
position.
After the cleaning cycle is completed,
verify that all build-up has been removed. If
not repeat the clean cycle procedure.
Optional: After the cleaning cycle has
been completed , you may wash the
interior with a mild detergent / dish soap
or a solution of two tablespoons of baking
soda and one quart of water. Rinse with
clean water.
Replace the splash shield (if removed and
grid cutter cover.
Your ice machine is now ready to restart.
Press and hold the "ON/OFF"
icon for 3 seconds until "ICE is
displayed.
NOTE
After cleaning discard all of the ice produced
within the first 3 hours of operation.
17
ICE
CLEAN
OFF
ICE