Electrolux UL15IM20RS Use And Care Manual page 25

Problem
Unit runs but
produces very little
ice.
Ice is slow to
release or does not
release from the
evaporator.
Poor ice quality
(soft or unclear).
Unit produces
shallow or
incomplete cubes,
or the ice fill pattern
on the evaporator
is incomplete.
Water leaking from
under the unit.
Ice storage bin full
of water.
Possible Cause
• Dirty condenser coils.
• High air temperature
around unit.
• Scale and mineral
buildup in unit.
• Inadequate airflow at
the front of the unit.
• Missing or loose
reservoir drain plug.
• Cleaning cycle recently
performed.
• Ice-making system is
dirty.
• Unit is not level.
• Poor incoming water
quality.
• Ice-making system is
dirty.
• Low water level.
• Hot incoming water.
• Incorrect incoming
water pressure.
• Unit is not level.
• Supply line leaking.
• Fill tube leaking.
• Bin drain leaking.
• Unit not level
• Obstructed drain.
Troubleshooting
Remedy
• Clean the condenser. See
Maintenance.
• Surrounding air temperature
of over 90°F (32°C). Low
ice production at high
temperatures is normal.
• Clean unit. See Maintenance.
• Remove items blocking airflow.
• Make sure reservoir drain plug
is securely in place.
• Allow unit to reach the set
temperature to produce ice
normally.
• Run unit through automatic
clean cycle. See Maintenance.
• See Leveling the Unit.
• Consult a qualified plumber
to test the water quality and
recommend appropriate
treatment.
• Run unit through automatic
clean cycle. See Maintenance.
• Check to see that overflow
tube is fully seated.
• Connect the unit to a cold
water supply. See Installation.
• Water pressure must be 20 -
120 ps.
• See Leveling the Unit.
• Check to see that the water
inlet line is attached to inlet
valve properly. See Connecting
the Water Supply.
• Check connection at water
valve outlet.
• Check integrity of bin drain
hose and clamp.
• See "Leveling the Unit" section.
• Check to see that storage
bin drain opening is free from
obstruction and debris. Check
pump and drain line.
25