Replacing the Palm Rest
1. Align the palm rest with the base and gently snap the palm rest into place.
2. Reconnect the touch-pad connector to the system board.
3. Reconnect the LED board connector to the system board.
4. Replace the coin-cell battery, if appropriate (see
5. Reconnect the coin-cell battery cable to the system board.
6. Replace the six M2.5 x 5-mm screws on the top side of the palm rest.
7. Turn the computer upside down, and replace the 12 M2.5 x 8-mm screws on the bottom of the computer.
8. Replace the display assembly (see
9. Replace the keyboard (see Keyboard).
10. Replace the hinge cover (see
Back to Contents Page
Replacing the Coin-Cell
Replacing the Display
Replacing the Hinge
Cover).
Battery).
Assembly).