Dell XPS M1710 Service Manual page 49

Hide thumbs Also See for XPS M1710:

Table of Contents

1 display panel

4 grounding wire and captive screw

CAUTION:

Before you begin the following procedure, follow the safety instructions in the Product

Information Guide.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an

unpainted metal surface (such as the back panel) on the computer.

NOTICE:

To help prevent damage to the system board, remove the main battery (see

Computer) before working inside the computer.

1. Follow the instructions in

2. Remove the display assembly (see

3. Remove the display bezel (see

4. Loosen the captive ground screw that attaches the display-panel ground wire to the display back cover.

5. Remove the eight M2 x 3-mm screws (four on each side of the display panel).

6. Lift the display panel out of the display back cover.

7. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display

connector.

8. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.

2 M2 x 3-mm screws (8)

Before Working Inside Your

Removing the Display

3 display back cover

Computer.

Assembly).

Bezel).

Before Working Inside Your

Table of Contents

Mxg061