Replacing The Display Panel; Removing The Display Latch - Dell XPS M1710 Service Manual

Hide thumbs Also See for XPS M1710:

Table of Contents

1 pull-tab on bottom flex-cable

connector

4 inverter connector

Replacing the Display Panel

1. Reconnect the top display-cable connector to the top flex-cable connector.

2. Reconnect the bottom flex-cable connector to the inverter connector.

3. Replace the display panel inside the display back cover.

4. Tighten the captive screw that attaches the display-panel ground wire to the display back cover.

5. Replace the eight M2 x 3-mm screws (four on each side) around the display panel.

6. Replace the display bezel (see

Display Latch

CAUTION:

Before you begin the following procedure, follow the safety instructions in the Product

Information Guide.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an

unpainted metal surface (such as the back panel) on the computer.

NOTICE:

To help prevent damage to the system board, remove the main battery (see

Computer) before working inside the computer.

1. Follow the instructions in

2 top flex-cable

connector

Replacing the Display

Before Working Inside Your

3 display cable

connector

Bezel).

Computer.

Before Working Inside Your

Table of Contents

Mxg061