Assembly; Fitting The Loop Handle; Fitting The J-Handle; Fitting The Suspension Ring - Husqvarna 129DJx Operator's Manual

Fitting the loop handle

• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle. Fit the
nut, knob and screw. Do not overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt.

Fitting the J-handle

WARNING! Only grass blades/grass
!
cutters or trimmer heads/plastic blades
may be used when the J-handle is fitted.
Saw blades must never be used with the
J-handle.
Attach the J-handle to the loop handle using the three
screws, as shown.
Now carry out fine adjustment to give yourself a
comfortable working position. Tighten the screws.

ASSEMBLY

Fitting the suspension ring

Fit the suspension ring between the rear handle and the
loop handle. Position the hanging ring so that the machine
is balanced and comfortable to work with.
Use the harness and attach it to the suspension ring when
using grass blades.
Assembling and dismantling the
two-piece shaft
Assembly:
• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
• Push the attachment into the coupling until the
attachment snaps into place.
• Before using the unit, tighten the knob securely.
A
English
–
11