9.
Click the Erase-Program-Verify button. The progress bar will update. After some time, the status will
update to show successful completion.
DO NOT DISCONNECT THE USB CABLE OR POWER FROM THE NANOAVR WHILE THIS IS IN
PROGRESS. DOING SO MAY "BRICK" YOUR NANOAVR.
10. Click the Run Application button to reboot the nanoAVR.
11. Click the Disconnect button
12. Close the PIC32 Bootloader program window.
6.4 O
S
BTAINING
UPPORT
1. Check the forums on miniDSP.com to see if this issue has already been raised and a solution or solutions
provided.
2. Contact miniDSP via the support portal at
a. The specific product you are having an issue with (in this case, nanoAVR HD or nanoAVR HDA).
b. A clear explanation of the symptoms you are seeing.
c. A description of the troubleshooting steps (see
obtained.
mi niDSP Ltd, Hong Kong /
www.minidsp.com
minidsp.desk.com
Troubleshooting
/ Features and speci fi cations subject to change wi thout pri or noti ce
with:
above) you performed and the results
45
Need help?
Do you have a question about the NANOAVR HD and is the answer not in the manual?