Supply Voltage Connection - Webasto DUAL TOP RHA 100 Installation Instructions Manual

Electrical connections

15.1. Supply voltage connection

Use 12 V DC only.
Ensure that you take it directly from the vehicle's leisure battery.
Without any additional switches, so, just the Control Panel's switch.
Switching the heater on and off shall only be done with the Dual Top
Control Panel.
The fuse holder may only be installed in the interior of the vehicle.
Use fuses:
- 15 A
- 10 A
- 5 A
Each fuse shall be connected to the correct cable (color).
5 A: red / blue cable
10 A: red / black cable
15 A: red cable.
Make sure that yellow part is pushed into each fuse holder after
connecting cables. This prevents that cables may drop out when inserting
or replacing a fuse.
See Fig. 37.
NOTE:
When you replace a fuse, make sure that the Dual Top is switched off.
WARNING:
In case of electrical deviations a fuse other than specified may cause fire.
36
Fig. 36: Remove the fastening plate on the fuse holder
Fig. 37: Fuse holder, installation position
Dual Top