UM008 FMC204 User Manual
3 Installation
3.1 Requirements and handling instructions
The FMC204 daughter card must be installed on a carrier card compliant to the FMC
standard.
The FMC carrier card must support the high-pin count connector (HPC 400-pins).
The carrier card must support VADJ/VIO_B voltage of +2.5V (LVDS support) for
FMC204 revision 1. The carrier card can support VADJ/VIO_B voltage range of 1.65V
to 3.3V for FMC204 revision 2, but typically VADJ will be 1.8V or 2.5V for LVDS
operation.
Do not flex the card.
Prevent electrostatic discharges by observing ESD precautions when handling the
card.
3.2 LVDS requirements
Each D/A device has an independent DDR LVDS data bus. When a D/A device is operated
in single-channel mode, the full rate of 1Gsps is supported. The digital transfer rate can be
lowered by enabling the interpolation (x2 or x4) in the D/A devices. When the D/A devices
are operated in dual-channel mode, the maximum data rate without interpolation is 500
Msps. 1Gsps can be achieved using the times 2 interpolation in the D/A devices.
UM008
www.4dsp.com
r1.14
- 6 -