Dell Latitude CPi A-Series User Manual page 184

4. Place the Dell Diagnostics Diskette in the diskette drive and boot the computer.
NOTE: Before you read the rest of this chapter, you may want to start the Dell Diagnostics so you can
see the menus on your display.
When you start the diagnostics, the Dell logo screen appears, and a program tests the random-access
memory (RAM) that will be used by the diagnostics.
If a failure in RAM is detected, a message appears on the screen that tells you the memory address of the
defective memory module. Write down the memory address and see
obtaining technical assistance.
If no errors are found in RAM, the diagnostics loads and the Diagnostics Menu appears (see
menu allows you to exit to the MS-DOS
Figure 1. Diagnostics Menu
For a quick check of your system, select the Run Quick Tests option. This option runs only the subtests that
do not require user interaction and that do not take a long time to run. Dell recommends that you choose this
option first to increase the odds of tracing the source of the problem quickly. For a complete check of your
system, select the Run All Tests option. To check a particular area of your system, select the Run Specific
Tests option.
How to Use the Dell Diagnostics
When you select Run All Tests or Run Specific Tests from the Diagnostics Menu, the main screen of the
diagnostics appears (see
the configuration of the computer, and allows you to select options from a menu.
To select an option from the Diagnostics Menu, highlight the option and press <Enter>, or press the key
that corresponds to the highlighted letter in the option.
Information on the main screen of the diagnostics is presented in the following five areas:
®
prompt.
Figure 2). The main screen lists the diagnostic test groups, gives information about
Getting Help for instructions on
Figure 1). The