Fuse; Hull Finish - Evinrude E-TEC Operator's Manual

5) Start the engine and RUN AT IDLE
SPEED. Flush engine for at least five min-
utes. A steady stream of water must flow
from exhaust relief port of outboard.
1. Flushing device
2. Stream of water
7) Turn engine OFF. Leave the outboard in
vertical position long enough to completely
drain the powerhead.

FUSE

A blown fuse will not allow the engine to start.
Replace it with a fuse of the same rating. A
spare fuse is provided.
Fuse Replacement
NOTICE
Use only fuses of the same
rating. Your Evinrude E-TEC outboard
uses 10-amp fuses.
Remove engine cover. Install spare fuse in
place of failed fuse.
Detach fuse from plug by pulling down on fuse
connector clip. Install spare fuse in place of
failed fuse.
1. Fuse
008499
2. Spare fuse
NOTICE
securely may cause electrical problems.

HULL FINISH

The condition of your boat's bottom affects
performance. Marine growth or bottom paint-
ing may reduce speed and fuel efficiency.
For maximum performance, keep the boat's
running surface clean by rinsing it with fresh
water and wiping it dry. Apply Evinrude anti-
corrosion spray to any surface subject to cor-
rosion, but avoid the anti-corrosion anode(s).
1
2
Failure to install

S
ERVICE
002001
cover
47