Evinrude E-TEC Operator's Manual page 53

Outboard continues to run at slow idle
speed.
3) After outboard runs for another 15 sec-
onds:
For side mount controls, raise fast idle
lever again.
For binnacle or concealed side mount
controls, advance throttle handle to a po-
sition above HALF THROTTLE.
Outboard will accelerate to fast idle speed
and fog itself.
4) Allow outboard to run until it shuts itself
OFF automatically (less than one minute).
Winterization is complete when outboard
shuts itself off.
• If the outboard DOES NOT shut itself
off, you may not have used the fast idle le-
ver or button and the outboard was shifted
into gear.
• If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
In either event, immediately turn key switch
OFF and re-start the procedure.
Tiller Control Outboards
1) Advance throttle grip to a position above
HALF THROTTLE. Start the outboard.
Outboard runs at slow idle speed.
006458
Tiller Control – Typical
2) After outboard runs for about 15 seconds,
move throttle grip to IDLE position. Out-
board continues to run at slow idle speed.
006459
3) After outboard runs for another 15 sec-
onds, advance throttle grip to a position
above HALF THROTTLE. Outboard will
accelerate to fast idle speed and fog itself.
4) Allow outboard to run until it shuts itself
OFF automatically (less than one minute).
Winterization is complete when outboard
shuts itself off.
• If the outboard DOES NOT shut itself
off, you may not have properly advanced
throttle grip.
• If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
In either event, immediately press engine
cut-off switch to turn outboard OFF and re-
start the procedure.

S
TORAGE
007036
007037
007038
51