Shutting Down The Glomax ® Navigator Instrument; Operating The Glomax ® Navigator System - Promega GloMax GM2000 Operating Manual

2.B. Switching On the GloMax
4. The Tablet PC will begin its start-up protocol. After the operating software starts, tap on the GloMax
Navigator Software Icon to launch the GloMax
5. The GloMax
®
Exit Back
F igure 7. GloMax
2.C. Shutting Down the GloMax
1. Switch the instrument OFF using the On/Off switch on the back of the instrument.
2. Shut down the GloMax
3. Shut down the Tablet PC using normal Windows
the screen, select Settings, then select Power: Shut Down.
Note: When not in use for a prolonged period of time, the Tablet PC should be powered OFF.
!
If the Tablet PC is switched ON but is not connected to its power supply, it will go to Sleep mode after
15 minutes of inactivity. This does not happen if the Tablet PC is connected to its power supply.
2.D. Operating the GloMax
1. Open the door of the instrument and gently press the Microplate Sample Tray latch to release the tray cover
(Figure 5). If a lid is present, remove from plate. Insert an opaque 96-well plate such that well A1 of the
plate corresponds to the label "A1" on the plate tray (Figure 8).
2. Close the sample tray cover and the instrument door.
12
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · 608-274-4330 · Fax 608-277-2516
TM470 · 4/16
Navigator Instrument (continued)
®
Navigator System is now ready to use.
Navigator software Home Screen.
®
Navigator Instrument
®
Navigator Software by tapping on the "x" in the upper right corner (Figure 7).
®
Navigator System
®
Navigator software.
®
8 shutdown procedures: Swipe in from the right edge of
®
®
Tools Eject Help
www.promega.com