Dell Adamo XPS Service Manual page 58

1. Follow the instructions in Before You
2. Place the left daughter board on the base of the computer.
3. Replace the two screws that secure the left daughter board to the computer base.
4. Connect the touch pad cable, speaker cable, and the bridge battery cable to the connectors on the left daughter board.
5. Connect the left daughter board cable to the connectors on the system board and the left daughter board.
6. Replace the palm rest assembly (see
7. Replace the computer battery (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Removing the Right Daughter Board
1. Follow the instructions in Before You
2. Remove the computer battery (see
3. Open the display (see Opening the
4. Remove the palm rest assembly (see
5. Remove the solid state drive (see
6. Remove the Bluetooth card (see
7. Remove the WLAN card (see
8. Disconnect the right daughter board cable from the connector on the system board.
9. Lift and slide the right daughter board away from the computer.
1 right daughter board cable
Replacing the Right Daughter Board
1. Follow the instructions in Before You
2. Slide and place the right daughter board towards the edge of the computer.
3. Connect the right daughter board cable to the connector on the system board.
4. Replace the WLAN card (see
Begin.
Replacing the Palm Rest Assembly).
Replacing the Computer Battery).
Begin.
Removing the Computer Battery).
Display).
Removing the Palm Rest Assembly).
Removing the Solid State Drive).
Removing the Bluetooth Card).
Removing the WLAN Card).
2 right daughter board
Begin.
Replacing the WLAN Card).