Replacing The System Board - Dell Adamo XPS Service Manual

1 thermal fan cable connector
3 left I/O board cable connector
5 AC adapter power cable connector
7 screws (2)
16. Lift the system board at an angle towards the side of the computer and out of the computer base.
Replacing the System Board
1. Follow the instructions in Before You
2. Place the system board on the computer base.
3. Replace the two screws that secure the system board to the computer base.
4. Connect the following cables to their corresponding connectors on the system board:
thermal fan cable
l
display cable
l
left I/O board cable
l
battery power cable
l
AC adapter power cable
l
right I/O board cable
l
5. Route the antenna cables and tape them in place if required.
2 display cable connector
4 battery power cable connector
6 right I/O board cable connector
Begin.