Replacing The Display Assembly - Dell Adamo XPS Service Manual

1 screws (2)
10. Slide and lift the computer base away from the display assembly.
NOTE: Remove the service tag panel if you are replacing the display assembly (see
Replacing the Display Assembly
1. Follow the instructions in Before You
2. Place the computer base in position and replace the two screws that secure the display assembly to the computer base.
3. Route the antenna cables and tape them in place if required.
4. Connect the following cables to their corresponding connectors on the system board:
display cable
l
left I/O board cable
l
battery power cable
l
AC adapter power cable
l
right I/O board cable
l
5. Replace the Bluetooth™ card (see Replacing the Bluetooth
6. Replace the WLAN card (see
7. Replace the palm rest assembly (see
NOTE: Replace the service tag panel if you are replacing the display assembly (see
8. Replace the computer battery (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Card).
Replacing the WLAN Card).
Replacing the Palm Rest Assembly).
Replacing the Computer Battery).
Removing the Service Tag Panel).
Replacing the Service Tag Panel).