Ip Connectivity Test (Ping) - Alcatel OmniStack 8008 User Manual

Parameter Default

IP Connectivity Test (Ping)

Use the IP Connectivity Test to see if another site on the Internet can be reached.
The screen shown below is described in the following table.
IP address to perform the connectivity test.
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
IP Address
Test Times
Interval
Success/Failure
Description
BOOTP-GET-IP - IP is enabled but will not function until a BootP
reply has been received. BootP requests will be broadcast 10
times, once every second, in an effort to learn its IP address. If no
response is received, the switch will use the default IP setting in
NVRAM. (BootP values can include the IP address, default
gateway, and subnet mask.)
Alcatel OmniStack 8008
< IP Connectivity Test(Ping) >
IP Address :
Test Times : 1
Success : 0
[Start]
Description
IP address of the site you want to ping.
The number of ICMP echo requests to send to the specified site.
Range: 1~9999
The interval (in seconds) between pinging the specified site.
Range: 1~10 seconds
The number of times the specified site has responded or not to pinging.
Management Setup Menu
Interval : 3
Failure
<OK>
: 0
| READ/WRITE
2-11