Changing the Network Configuration
Use the Network Configuration menu to set the bootup option, configure the switch's
Internet Protocol (IP) parameters, enable the on-board Web server, or to set the
number of concurrent Telnet sessions allowed. The screen shown below is
described in the following table.
Parameter
IP Configuration
IP Connectivity Test
HTTP Configuration
MAX Number of Allowed
Telnet Sessions
Physical Address
Alcatel OmniStack 8008
< Network Configuration >
IP Configuration
IP Connectivity Test(Ping)
HTTP Configuration
MAX Number of allowed Telnet sessions (1-4) : 4
Physical Address : 00-00-11-11-43-21
<APPLY>
Display or change IP configuration.
Use <TAB> or arrow keys to move. <Enter> to select.
Description
Screen used to set the bootup option, or configure the switch's IP parameters.
Screen used to test IP connectivity to a (Ping) specified device.
Screen used to enable the Web server.
The maximum number of Telnet sessions allowed to simultaneously access
the switch.
MAC address of the switch.
Management Setup Menu
<OK>
<CANCEL>
2-9