Registering The Telephone; Registering The Telephone On A System For The First Time - Alcatel-Lucent 8232 DECT Handset User Manual

8232 DECT Handset

8 Registering the telephone

8.1 Registering the telephone on a system for the first time

For the mobile telephone to function, it must be registered on at least one ALE International or GAP system
(registration operation).If when first switched on the display indicates: 'System 1 Auto install ?' your
telephone has not been registered on any system

Auto install?

Confirm.
Registration can begin.
A- If the system does not use an AC code.

Launch subscription.
B- If the system uses an AC (authentication code).

Register

Enter the PIN Code (The default is 0000).

Apply.

Select a system (It is recommended that the first empty system is selected).

Apply.

Enter PARK code (enter nothing if not mandatory).

Apply.

Enter access code (enter nothing if not mandatory).

Apply

Select Power mode (You are advised not to select the 50 mW power mode unless required.
The '50mW power mode' is intended for hazardous sites such as nuclear plants where it is
requested that emissions do not exceed the maximum value.).

Legacy Mode:

Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
The registration operation can last up to 2 minutes.

If the operation has been done correctly (subscription accepted), the telephone is ready to be used
and the radio reception quality icon is displayed.

If the registration operation has not been successful, the station proposes launching the subscription
again.
8AL90862USABed01
40 /55