Yamaha SUPER TENERE XT1200Z Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
 To prevent accidentally activat-
ing the cruise control system,
turn it off when not in use. Make
sure that the cruise control sys-
tem indicator light "
3
1 2
1. Cruise control system indicator light "
2. Cruise control setting indicator light "SET"
1. Cruise control setting switch "RES+/SET–"
2. Cruise control power switch "
Activating and setting the cruise
control system
1. Push the cruise control power
switch "
" is off. handlebar. The cruise control sys-
tem indicator light "
on.
2. Push the "SET–" side of the cruise
control setting switch to activate
the cruise control system. Your
current traveling speed will be-
come the set cruising speed. The
cruise control setting indicator
light "SET" will come on.
"
Adjusting the set cruising speed
While the cruise control system is op-
erating, push the "RES+" side of the
cruise control setting switch to in-
crease the set cruising speed or the
"SET–" side to decrease the set speed.
TIP
1
Pushing the setting switch once will
change the speed in increments of ap-
proximately 2.0 km/h (1.2 mi/h). Hold-
2
ing the "RES+" or "SET–" side of the
"
" located on the left
" will come
3-7
cruise control setting switch down will
increase or decrease the speed contin-
uously until the switch is released.
You can also manually increase your
traveling speed using the throttle. After
you have accelerated, you can set a
new cruising speed by pushing the
"SET–" side of the setting switch. If you
do not set a new cruising speed, when
you return the throttle grip, the vehicle
will decelerate to the previously set
cruising speed.
Deactivating the cruise control sys-
tem
Perform one of the following opera-
tions to cancel the set cruising speed.
The "SET" indicator light will go off.
 Turn the throttle grip past the
closed position in the deceleration
direction.