Basic components
EMU26410
2-pin connector
AC 12 V-40/60/80W power is delivered
through this connector. When using it, keep
in mind the following points:
Use a genuine Yamaha connector.
G
Use lighting equipment only.
G
Connect lighting equipment directly to the
G
2-pin connector.
Capacity of the lighting equipment must be
G
more than 12 V-40/60/80W; otherwise the
bulb could burn out.
When the connector is not in use, place
G
the cap on it.
ECM01000
CAUTION:
Do not connect the 2-pin connector di-
rectly to the battery terminals. Otherwise
the electric system will be damaged.
EMU26420
Battery charging information
If you need to charge the battery, use a gen-
uine charge cable to make the charging cir-
cuit.
For details on the cable connections, consult
your Yamaha dealer.
NOTE:
Do not use the 2-pin connector while
G
charging. The battery will not be charged.
If you need to use lighting equipment while
G
charging the battery, connect it to the bat-
17
tery, not to the 2-pin connector.
EMU26302
Warning indicator
If the engine develops a condition which is
cause for warning, the indicator lights up. For
details on how to read the warning indicator,
see page 17.
ZMU03703
1. Warning indicator
EMU26801
ECM00090
CAUTION:
Do not continue to operate the engine if a
warning device has activated. Consult
your Yamaha dealer if the problem can-
not be located and corrected.
EMU26817
Overheat warning
This engine has an overheat-warning de-
vice. If the engine temperature rises too high,
the warning device will activate.
Activation of warning device
The engine speed will automatically de-
G
crease to about 2000 r/min.
If equipped with an overheat-warning indi-
G
cator, it will light or blink.
Warning system
1
ZMU03704