Basic components
mal running position, use an additional
support device to secure it in the tilt posi-
tion.
EMU26372
Top cowling lock lever(s) (turn type)
To remove the engine top cowling, turn the
lock lever(s) and lift off the cowling. When in-
stalling the cowling, check to be sure it fits
properly in the rubber seal. Then lock the
cowling again by returning the lever(s) to the
lock position.
1. Top cowling lock lever(s)
EMU26410
2-pin connector
AC 12 V-40/60/80W power is delivered
through this connector. When using it, keep in
mind the following points:
Use a genuine Yamaha connector.
G
Use lighting equipment only.
G
Connect lighting equipment directly to the
G
2-pin connector.
13
Capacity of the lighting equipment must be
G
more than 12 V-40/60/80W; otherwise the
bulb could burn out.
When the connector is not in use, place the
G
cap on it.
ECM01000
CAUTION:
Do not connect the 2-pin connector direct-
ly to the battery terminals. Otherwise the
electric system will be damaged.