2-Pin Connector; Battery Charging Information - Yamaha 15F Owner's Manual

Components
it fits properly in the rubber seal. Then lock
the cowling again by returning the cowling
lock lever(s) to the lock position.
1. Cowling lock lever(s)
EMU26411

2-pin connector

AC 12 V-40/60/80W power is delivered
through this connector. When using it, keep
in mind the following points:
 Use a genuine Yamaha connector.
 Use lighting equipment only.
 Connect lighting equipment directly to the
2-pin connector.
 Capacity of the lighting equipment must be
more than 12 V-40/60/80W; otherwise the
bulb could burn out.
 When the connector is not in use, place the
cap on it.
17
ECM01001
NOTICE
Do not connect the 2-pin connector di-
rectly to the battery terminals. Otherwise
the electric system will be damaged.
EMU26421

Battery charging information

If you need to charge the battery, use a gen-
uine charge cable to make the charging cir-
cuit.
For details on the cable connections, consult
your Yamaha dealer.
TIP:
 Do not use the 2-pin connector while
charging. The battery will not be charged.
 If you need to use lighting equipment while
charging the battery, connect it to the bat-
tery, not to the 2-pin connector.