Duplicating A Video Tape - Orion TELETEXT 21FVD Operating Instructions Manual

DUPLICATING A VIDEO TAPE

If you connect the unit to another VCR or VIDEO CAMERA, you can duplicate a previously recorded tape.
Make all connections before turning on the power.
1
Load a blank cassette tape with the erase prevention
tab intact into the unit (these instructions show how
to use this unit as the recording, rather than the
playback device).
Load a previously recorded tape into the playback
VCR or VIDEO CAMERA.
2
Depending on the device that you are recording from,
you can use either the SCART socket at the rear or
the Front AV Input sockets. Press the AV button once
until "AV1" appears for recording through the SCART
socket or twice until "AV2" appears for recording
through the Front AV Inputs.
CONNECTION TO ANOTHER VCR
Playback VCR
21 pin SCART/PERITEL lead
(not supplied)
NOTES:
•
It is recommended that the tape speed be set to the SP mode on the unit for best results.
•
Unauthorized recording of copyrighted television programs, films, video cassettes and other materials may infringe
the rights of copyright owners and be contrary to copyright laws.
32
3
4
5
CONNECTION TO CAMCORDER
For duplicating a previously recorded tape from a camcorder,
follow the camcorder manufacturer's instructions. A typical
camcorder dubbing hookup is shown below.
Recording unit
Playback
Camcorder
VIDEO lead
(not supplied)
Press REC/OTR on the remote control of the unit,
then press PAUSE/STILL.
Press the PLAY button on the playback VCR, then
press the PAUSE button.
Release the Recording Pause and Still Playback to
begin the duplicating process.
To AV Jack
AUDIO/
TO VIDEO IN
Recording unit
TO AUDIO(R) IN
TO AUDIO(L) IN