Picture Control Adjustments - Orion TELETEXT 21FVD Operating Instructions Manual

The picture settings have been factory
adjusted under optimum signal recep-
tion. However, conditions may not be
the same in your area. After tuning in the
unit, allow it to warm up for a few min-
utes. If the picture is not to your liking,
make the following adjustments using
the remote control.
NOTE:
To resume the normal picture adjust-
ment, press CANCEL, while in the
picture mode menu.

PICTURE CONTROL ADJUSTMENTS

Preparation
Press TV/VCR to select TV/VCR mode.
1
To adjust the picture, press
MENU.
Press ▲ or ▼ to select the TV
SETUP mode, then press
ENTER.
2
Press ▲ or ▼ to select the
PICTURE mode, then press
ENTER.
3
Press ENTER until your desired
PICTURE mode appears e.g.
brightness, contrast, colour,
sharpness. Then press
adjust the level of the PICTURE.
(See below for details.)
4
After finishing the adjustment, press MENU 3 times to
return to normal TV screen.
Each time you press ENTER the picture adjustment Screen
changes as follows.
BRIGHTNESS
Press ENTER until "BRIGHTNESS" appears on the screen, then
press or
darker portions of the picture become lighter.
CONTRAST
Press ENTER until "CONTRAST" appears on the screen, then
press or
contrast and enhances the colour. Picture looks sharper in the
daytime by increasing the contrast level and sharper at night by
lowering the contrast level.
COLOUR
Press ENTER until "COLOUR" appears on the screen, then press
or to adjust the intensity of the colours. This should be set to
where the colours appear normal in intensity and brilliance.
SHARPNESS
Press ENTER until "SHARPNESS" appears on the screen, then
press or
In weak reception areas, the picture may be more pleasing when
the SHARPNESS is set at a lower level.
NOTES:
•
The picture settings can only be adjusted by using
and ENTER when they are displayed on the screen.
•
Press MENU 3 times to return to normal TV screen.
•
The On-screen display will disappear about one minute
after finishing an adjustment.
SELECT
ENTER
EXIT
TV SETUP
SELECT
ENTER
EXIT
or to
SET
RESET
NEXT
to adjust the brightness. When
to adjust the contrast. Pressing
to adjust the sharpness.
TIMER REC SET
AUTO REPEAT OFF
CHANNEL SETUP
TV SETUP
SYSTEM SETUP
:
: ENTER
: MENU
ON/OFF TIMER SET
PICTURE
AUTO
NICAM
:
: ENTER
: MENU
BRIGHTNESS 0
: EXIT : MENU
: CANCEL
: ENTER
is pressed, the
improves the
or
17