Timer Recording - Orion TELETEXT 21FVD Operating Instructions Manual

Timer recording can be programmed
on screen with the remote control.
The built-in timer allows automatic
unattended recording of up to 8
programmes within 1 month.
NOTES:
•
If programming is performed without a
tape in the unit, or with a tape without
an erase prevention tab, Timer
Recording is not possible. If a tape
without an erase prevention tab is in
the unit, the tape will be ejected.
•
To record from external equipment
connected via the SCART socket
(AV1) or the front AV socket (AV2),
press or repeatedly until "AV1" or
"AV2" appears when setting the channel
in step 5.
•
The VCR section cannot be used
while the TIMER REC indicator is lit. If
you want to use the VCR operation,
press TIMER REC to deactivate the
timer.
•
If there is a power failure, the power
plug is disconnected, or the MAIN
POWER (ON) Switch is switched off
for more than approx. 30 mins, all
programmed timer recordings and
clock settings will be lost. In this case,
reset the clock (see page 11) and
reprogram any timer recordings.
•
If you want to correct the digits while
setting, press ▲ until the item you
want to correct flashes, then press
or to correct the desired setting.

TIMER RECORDING

Preparation
•
Load a cassette tape with the erase prevention tab intact.
The unit will automatically turn on.
•
Make sure that the clock shows the present time correctly.
EXAMPLE:
Programme a timer recording for 13:00-14:30, channel 3, on timer
programme number 1 (Tape speed : LP).
1
Press TV/VCR to select TV/VCR mode.
Press MENU.
2
Check that the TIMER REC
SET option is selected, then
press ENTER.
3
Press ▲ or ▼ to select one of
the program lines, then press
ENTER.
4
Press or to select the desired
date or every day or every week
setting, then press ▼.
5
Set the start time, end time,
channel and tape speed as in
step 4.
When you have finished setting
all your recordings, press
ENTER. Press the MENU twice
to return to normal TV screen.
• When you set the minute, you
can change in 10-minutes step
by holding down .
6
To set the timer for another programme, press ▲ or ▼
until a blank programme line blinks, then press ENTER.
Repeat steps 4 to 5 to set the second programme.
7
Press TIMER REC. The TIMER REC indicator will light.
The Timer is programmed, when the programmed time is
reached, the recording is automatically started.
To cancel timer recording, press the button again and
TIMER REC indicator will go out.
TIMER REC SET
AUTO REPEAT OFF
CHANNEL SETUP
TV SETUP
SYSTEM SETUP
SELECT :
ENTER : ENTER
EXIT : MENU
SELECT : / ENTER
EXIT : MENU
TIMER REC SET
DATE 23 SAT
START 11 : 30
END – – : – –
CH 1
SPEED SP
SELECT :
/ 0 - 9
SET :
EXIT : MENU
TIMER REC SET
DATE 23 SAT
START 13 : 00
END 14 : 30
CH 3
SPEED LP
SELECT :
SET :
EXIT : MENU OK : ENTER
23 SAT 13 : 00 14 : 30 3 LP
: :
: :
: :
: :
: :
: :
: :
SELECT : / ENTER
EXIT : MENU
TIMER REC
25