Loading And Unloading The Video Cassette Tape - Orion TELETEXT 21FVD Operating Instructions Manual

LOADING AND UNLOADING THE VIDEO CASSETTE TAPE

Use only video cassette tapes marked
Preparation: Press TV/VCR to select TV/VCR mode.
LOADING
Push the centre of the tape until it is automatically inserted.
AUTOMATIC POWER ON AND PLAY (Make sure that the MAIN POWER switch is pushed in.)
When loading a cassette tape without the erase prevention tab intact, the unit will turn on and playback will
start immediately.
Insert the cassette with its labelled side facing you.
An inverted cassette cannot be inserted.
UNLOADING
1
To unload a video cassette, press EJECT on the
remote control, or press the
button on the unit twice. The first press will stop
the tape in any mode. The second press will
eject the tape.
AUTOMATIC EJECT
When the unit is automatically rewinding the tape and
reaches its end (AUTO REWIND), the tape will be ejected
automatically (See NOTE on page 24).
•
NOTES: Always eject the tape when not in use.
•
The cassette can be ejected even if the ON (
TO PREVENT ACCIDENTAL ERASURE
After recording, break off the erase prevention tab if
you do not wish to record over the tape.
Erase prevention tab
TAPE SPEED AND MAXIMUM RECORDING/PLAYBACK TIME
TAPE SPEED
SP (Standard Play )
LP (Long Play)
20
.
PAL SECAM
(STOP/EJECT)
TO RECORD AGAIN
Screwdriver
E-300 E-240
5 hours 4 hours
10 hours 8 hours
2
Pull the cassette out.
) button is OFF.
Cover the hole with adhesive tape.
Be careful the tape does not extend past the edges of
the cassette housing.
Adhesive tape
VIDEO CASSETTE TAPE
E-180
E-90
3 hours
1-1/2 hours
6 hours 3 hours
E-60 E-30
1 hour 30 minutes
2 hours 1 hour