Nicam Stereo Recording And Playback/Reception Disturbance - Orion TELETEXT 21FVD Operating Instructions Manual

NICAM STEREO RECORDING AND PLAYBACK/RECEPTION DISTURBANCE

RECORDING
This unit is capable of recording sound in Hi-Fi system. NICAM STEREO broadcasts are recorded in its original sound system
automatically. If the NICAM sound has noise, select NICAM "OFF" as follows.
Press TV/VCR to
select TV/VCR
mode. Then press
MENU.
SELECTING STEREO OR BILINGUAL SOUND FOR A PRE-RECORDED TAPE
Press AUDIO to select stereo/mono or bilingual playback. See the table below for more information.
Stereo
On-screen indications
programme
(for 4 sec.)
Stereo
STEREO
Left channel
signal output
from both
loudspeakers
L CH
NOTE: When playing HiFi cassette tapes recorded on another VCR, the sound output may be distorted. This is normal and no
indication of a unit malfunction. Try to minimize sound distortions by using TRK/SKIP +/– buttons or change to MONO
by pressing of AUDIO.
RECEPTION DISTURBANCE
The most common types of television interference are as follows.
IGNITION
Black spots or horizontal streaks may appear, picture may flutter
or drift. Usually caused by interference from car ignition systems,
neon lamps, electrical drills and other electrical appliances.
SNOW
If your receiver is located in the fringe area of a television station
where the signal is weak, your picture may be marred by the
appearance of small dots. When the signal is extremely weak, it may
be necessary to install a special antenna to improve the picture.
CARE AND MAINTENANCE
To prevent fire or shock hazard, disconnect the unit from the AC power source before cleaning. The finish on the cabinet may be
cleaned with mild soap and a soft damp cloth. Take care when cleaning or wiping the plastic parts.
VIDEO HEAD CLOGGING
The video heads record and playback picture and sound on the video tape. In the event that they become dirty you won't be able to do a perfect
recording and the playback picture will be extremely snowy with good sound. If this happens have the unit checked by qualified service personnel.
VIDEO HEAD CLEANING
Manual head cleaning is needed if the picture on playback is still unclear although the picture on program is normal. This failure
signifies that the head is getting dirty and can occur when playing poor quality or damaged tapes. If the heads require cleaning,
use a high quality head-cleaning cassette or have them cleaned professionally.
NOTES:
•
Video heads may eventually wear out and should be replaced when they fail to produce clear pictures.
•
To help prevent video head cleaning, use only good quality VHS tapes. Discard worn tapes.
▲ or ▼ to
Press
select the TV
SETUP mode, then
press ENTER.
TIMER REC SET
AUTO REPEAT OFF
CHANNEL SETUP
TV SETUP
SYSTEM SETUP
SELECT :
ENTER : ENTER
EXIT : MENU
Bilingual On-screen indications
programme
(for 4 sec.)
Main sound
from L CH
speaker, sub
sound from R
R CH
CH speaker.
Main (MONO
A) sound
heard from
both
MONO
speakers.
▲ or ▼ to
Press
select the NICAM
mode. Then press
to select [OFF].
TV SETUP
ON/OFF TIMER SET
PICTURE
NICAM [OFF]
SELECT : /
ENTER : ENTER
EXIT : MENU
HI-FI SIGNAL INDICATION
Stereo
Bilingual
programme programme
Right channel Sub (MONO
B) sound
signal output
from both heard from
loudspeakers both
speakers.
Mono Main (MONO
A) sound
heard from
both
speakers.
GHOSTS
Ghosts are caused by the television signal following two paths.
One is the direct path and the other is reflected from tall buildings,
hills or some other object. Changing the direction or position of the
antenna may improve the reception.
RADIO FREQUENCY INTERFERENCE
The interference produces moving ripples or diagonal streaks,
and in some cases, causes loss of contrast in the picture.
Press MENU to
return to normal TV
screen.
Hi-Fi signal indication
Press DISPLAY.
It will be displayed for approx.
4 seconds when playing HiFi
video cassette tapes.
TV/VCR
11:30 SAT
HI-FI
STEREO
00:03:01 SP
31