NordicTrack T14.0 NETL12710.2 User Manual page 11

9. With the help of a second person, hold the sides
of the console assembly and position the con-
sole assembly near the Right Upright (83) and
the Left Upright (not shown). Do not lift the
console assembly by the Right Handrail (79)
or the Left Handrail (not shown).
Connect the Upright Wire (85) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
10. Slide a Handrail Cover (77) onto the lower end
of each Handrail (78, 79).
Set the console assembly on the Left and Right
Uprights (82, 83). At the same time, insert the
lower end of the Handrails (78, 79) over the
brackets on the Uprights. Be careful not to
pinch any wires. Insert the excess wire into the
Right Upright.
Start four 5/16" x 3/4" Patch Bolts (5) with four
5/16" Star Washers (9) into the Uprights (82,
83). Then, start two 5/16" x 1 1/2" Patch Bolts
(4) with two 5/16" Star Washers (9) into the
Uprights. Do not tighten the Patch Bolts yet.
9
Console
Assembly
Console
Wire
Wire
Tie
10
Console
Assembly
9
5
4
9
79
77
Bracket
83
11
79
85
Console
Wire
85
83
5
9
77
Bracket
82
4
9
78