Programming The Weather Station (Receiver/Base Unit); Automatic Search Function (Searching For Signals); Manual Search Function (Searching For Signals) - Clas Ohlson WS2068HL+WT450H Manual

Programming the weather station (receiver/base unit)

Automatic search function (searching for signals)

1. The memorisation function starts
automatically when the batteries are
inserted into the weather station and
lasts 3 minutes.
2. During these three minutes the weather
station (receiver) receives temperature
and humidity signals from the sensor
transmitter
Note! The wireless transmission range is affected by the material of the building
and distance between sensor transmitter and receiver. Try different locations
for the weather station (receiver) and sensor transmitter until you find the best
reception.

Manual search function (searching for signals)

If a new wireless sensor transmitter is added to your weather station (or if the
signal is lost), the search function must be repeated.
1. Press and hold [Alarm/Channel] (5) for 3
seconds.
2. A buzzer indicates that the search function
has begun.
3. The channel number of every sensor found
will flash on the display.
4. The present temperature and humidity
readings from the sensor appear on the
"Outdoor" display.
2
1
5
1
2
2
1

1 OUT
3
4
OUT
1
1 OUT
4
4
3
3
4
OUT
1